Encoder Lines - Parker AC890 Product Manual

Frame g, h & j

Hide thumbs Also See for AC890:

Table of Contents

SETUP::MOTOR CONTROL::ENCODER

This block is used to set up the way that speed feedback is obtained via the feedback option card. Different encoder types may

be selected including pulse encoder, sincos encoder and absolute single turn or multi turn. Different encoder types require

different hardware options. If an encoder type is selected which does not match the hardware, an error will be flagged.

Parameter Descriptions

PULSE ENC VOLTS

Set this approximately to the supply voltage required by the pulse encoder.

SINCOS ENC VOLTS

Used to set the supply volts required by the sin/cos encoder.

Enumerated Value : SinCos Encoder Volts

ENCODER LINES

The number of lines must be set to match the type of encoder being used. Incorrect setting of this parameter will result in an

erroneous speed measurement and will cause the motor to become unstable.

Default: 10.0 V

Default: 5.0 V

Default: 2048

890SD Standalone Drive - Frames G, H & J

Range: 10.0 to 20.0 V

Range: See below

Range: 250 to 262143

Show Quick Links

Table of Contents