COMMS PORT
SETUP:: SEQ & REF::COMMS PORT
Designed for all Motor Control Modes.
This function block allows you to set the mode for the P3 Comms Port (keypad port).
Parameter Descriptions
MODE
This parameter
Enumerated Value : Mode
D-22
Page
PREF: 129.01
0 : AUTOMATIC (senses if either 6511 or 6901 operator station is present)
1 : 6511 OP STATION
2 : 6901 OP STATION
3 : TS8000 HMI
Default: AUTOMATIC
890SD Standalone Drive - Frames G, H & J
Range: Enumerated - see below