Associated Equipment
The original exhaust duct supplied with the drive or the exhaust duct supplied with the brake unit may be used
in the final installation.
The brake unit consists of the following parts:
Exhaust Duct.
Heatsink & IGBT assembly.
Control cable.
Brake connection plates - 1 set for Frame G/H and 2 sets for Frame J.
Heatsink fixings.
Brake unit cover and retaining nuts.
Earth bonding bracket.
The brake unit is shipped in a pre-assembled state (except for the connection plate(s)). It is recommended that
this assembly is carefully studied prior to installation within the cubicle. We also recommend that the brake
unit heatsink/IGBT assembly is removed from the exhaust duct before installing the unit within the cubicle.
Required tools
M10 spanner
#3 posidrive or phillips torque screwdriver
#2 posidrive or phillips torque screwdriver
Installation Procedure
Disconnect all electrical supplies before working on the drive - allow 15 minutes for the drive dc link
5-7
Page
Follow the procedure carefully.
capacitors to fully discharge.
Do not drop any screws, nuts or extraneous parts into the drive.
WARNING
890SD (Standalone) Drive: Frame G, H & J