Mounting The Drive; Mechanical Details - Parker AC890 Product Manual

890SD Standalone Drive

Mounting the Drive

Prepare a clear, flat surface to receive the drive before attempting to move it. Do not damage any terminal
connections when putting the drive down.
IMPORTANT Under no circumstances must the drive be lifted using the power terminals.
The drives are supplied with 4 lifting eye bolts fitted to the 4 PE/grounding locations on the sides of the
drive for handling using a hoist.
Frames G and H may be set on end for installation by forklift. Frame J may be placed on forklift blades
with care to avoid the fan mounting studs and fan power terminals on the bottom (with the fan removed -
the fan is shipped separately from the drive).
IMPORTANT
The 890 drive must be securely mounted using all 10 off M8 mounting hole positions as detailed on
HG465731U00. Refer to the drawings at the end of this chapter.
It must be mounted inside a suitable cubicle, depending upon the required level of EMC compliance.

Mechanical Details

Frame G
Weight
Dimensions
Frame H
Weight
Dimensions
Frame J
Weight
Dimensions
4-8
Page
100kg (108kg including Dynamic Brake unit)
Refer to drawing HG465731U003
125kg (138kg including Dynamic Brake unit)
Refer to drawing HG465731U002
160kg (176kg including Dynamic Brake unit)
Refer to drawing HG465731U001
890SD (Standalone) Drive: Frame G, H & J