Parker AC890 Product Manual page 270

Enable Ramp Output, Enable Ramp, Enable Ramp Input
Not implemented. The state of these bits must be set (=1) to allow this feature to be added in the future.
Reset Fault
Replaces the REM TRIP RESET parameter on the SEQUENCING LOCIC function block. When Set (=1)
is the same as:
REM TRIP
RESET
When Cleared (= 0) is the same as :
REM TRIP
RESET
Remote
Not implemented. It is intended to allow the PLC to toggle between local and remote. The state of this must
be set (=1) to allow this feature to be added in the future.
Example Commands
890SD (Standalone) Drive: Frame G, H & J
= TRUE
= FALSE
047F hexadecimal to RUN
047E hexadecimal to STOP
Sequencing Logic
B-11
Page