Parker AC890 Product Manual page 33

890SD Standalone Drive
Tools Required:
M10 wrench, quantity 2
#3 Phillips or posidrive screwdriver
10mm (3/8") flat blade screwdriver
Assembly Procedure
On cabinets with removable panels the following procedure should be performed off the cabinet. For non-
removable cabinets this procedure should be performed prior to mounting the drive.
Note If the drive is not removed, then it must be protected from any cutting chips.
1. Cut top of cabinet as per drawing HG465731U001 & HG465731U002 at the end of this chapter.
2. Install (4) M/M support studs in rearmost row of holes in pattern
3. Install (2) F/F M6 x 195 support studs in forward most holes with (2) M6 x 10 posidrive screws
Complete the following with the drive and exhaust duct fitted to ensure a good fit of the gasket to the duct.
4. Fit the gasket over the 4 support studs and exhaust duct.
5. Fit the mounting flange over the gasket and attach via (8) M6 x 25 screws, (16) M6 washers, and (8) M6
nuts.
6. Fit the top vent baffle over the support studs.
7. Fit grommet strip to bottom edge of grill and position.
8. Fit vent top over the 4 support studs and grill.
9. Fix vent top via (2) M6 x 10 screws (using a 10 mm wrench on the support studs through the grill is
helpful in aligning the stud to the hole in the top) and (4) M6 nuts and washers.
4-14
Page 890SD (Standalone) Drive: Frame G, H & J