Drive Name; Supply Voltage - Parker AC890 Product Manual

DRIVE CONFIG
SETUP::DRIVE SETUP::DRIVE CONFIG
This block contains general drive set-up parameters and also determines what hardware can be plugged in the A, B and F slots.
These parameters must be set correctly in order for the drive to run correctly.
Parameter Descriptions

DRIVE NAME

Enter a user name for the drive.
CONTROL MODE
This parameter defines how the drive will control the motor. If PMAC control is required, the motor wizard feature in the 890
DSE Configuration Tool MUST be used to correctly set-up the motor and feedback device parameters. Failure to do so may
result in damage to the servo motor.
Enumerated Value : CONTROL MODE

SUPPLY VOLTAGE

Changes the dynamic braking threshold on expected supply voltage range.
Enumerated Value : Supply Voltage
890SD Standalone Drive - Frames G, H & J
PREF: 136.01
PREF: 136.02
0 : VOLTS / Hz
1 : SENSORLESS VEC
2 : CLOSED-LOOP VEC
3 : 4-Q REGEN
4 : PMAC
PREF: 136.19
0 : 230V
1 : 380V to 480V
2 : 500V
3 : 575V
4 : 690V
Default: 890 DRIVE
Default: 0
Used to control Permanent-Magnet AC brushless motors.
Default: 380V to 460V
Range:
Range: See below
Range: See below
Page
D-25