Parker AC890 Product Manual page 7

Safety
WARNING! - Ignoring the following may result in injury or damage to equipment
Where there is conflict between EMC and Safety requirements, personnel safety shall always take precedence.
• Never perform high voltage resistance checks on the
wiring without first disconnecting the drive from the
circuit being tested.
• Whilst ensuring ventilation is sufficient, provide guarding
and /or additional safety systems to prevent injury or
damage to equipment.
• When replacing a drive in an application and before
returning to use, it is essential that all user defined
parameters for the product's operation are correctly
installed.
• In a domestic environment this product may cause radio
interference in which case supplementary mitigation
measures may be required.
• This equipment contains electrostatic discharge (ESD)
sensitive parts. Observe static control precautions when
handling, installing and servicing this product.
1-4
Page
SAFETY
• All control and signal terminals are SELV, i.e. protected
by double insulation. Ensure all external wiring is rated
for the highest system voltage.
• Thermal sensors contained within the motor must have at
least basic insulation.
• All exposed metalwork in the Inverter is protected by
basic insulation and bonded to a safety earth.
• RCDs are not recommended for use with this product but,
where their use is mandatory, only Type B RCDs should
be used.
EMC
• This is a product of the restricted sales distribution class
according to IEC 61800-3. It is designated as
"professional equipment" as defined in EN61000-3-2.
Permission of the supply authority shall be obtained
before connection to the low voltage supply.
890SD Standalone Drive - Frames G, H & J