Step 3: Control Connections - Parker AC890 Product Manual

890SD Standalone Drive

Step 3: Control Connections

Make sure the power is OFF, and that it cannot be switched on accidentally whilst you are working.
Main Points
♦ The 890 is a system product and is designed for Remote mode operation using the analog & digital
inputs/outputs and/or FireWire
purposes.
Connecting 890SD Standalone Drives using the FireWire
applications requiring high levels of accuracy. Otherwise, use I/O to transfer data from master to
slave units.
♦ The control terminals will accept a single wire of size 1.5mm
smaller gauge wire such as 0.5mm
♦ Use screened control cables to comply with EMC requirements. All screens must be terminated at the
base of the product using cable glands.
♦ The control board 0V at X14/04 must be connected to protective (clean) earth outside of the product to
meet EMC and safety requirements.
♦ Feed the control cables into the drive through the metal gland plate and connect to the control terminals.
Cables must be secured together with a cable tie as close to the terminals as possible.
4-28
Page
During commissioning, remove the fuses (or trip the circuit breaker) on your 3-phase supply.
TM
WARNING
connection. The use of the keypad (Local mode) is for configuration
2 /22AWG.
TM Option Cards is recommended for
2 /16AWG. For two wires per terminal, use
890SD (Standalone) Drive: Frame G, H & J