Parker AC890 Product Manual page 375

Parameter Descriptions
MAX VOLTAGE
Set the motor's maximum ac input voltage (in Volts rms).
THERM PROTECTION
Motor's thermal protection feature.
● MAX SPEED
Set the motor's maximum mechanical speed (in rpm)
● MAX CURRENT
Set the motor's maximum rms current. This parameter is used to limit the current demand
● PERM CURRENT
Set the motor's permanent rms current. Permanent current at low speed (in Amp rms) or nominal current.
Refer to MOTOR CURRENT % in the FEEDBACKS function block. A value of 100% = PERM CURRENT.
● PERM TORQUE
Set the motor's permanent torque.
Refer to TORQUE FEEDBACK in the FEEDBACKS function block. A value of 100% = PERM TORQUE.
LOW SPEED VALUE
Set the motor's low speed value (in rpm) below which the current must be reduced.
If this parameter is unknown, value must be set to 0 rpm.
● POLES
Set the number of motor poles, e.g. for a 4 pole motor enter "4".
D-84
Page
PREF: 134.05
PREF: 134.06
PREF: 134.07
PREF: 134.08
PREF: 134.09
PREF: 134.10
PREF: 134.11
PREF: 134.12
Default: 400.00
Default: FALSE
Default: 4300
Default: 10.60
Default: 4.90
Default: 6.40
Default: 0
Default: 10
890SD Standalone Drive - Frames G, H & J
Range: 20.00 to 640.00 V
Range: FALSE / TRUE
Range: 0 to INT MAX
Range: 0.00 to 4096.00 A
Range: 0.00 to 4096.00 A
Range: 0.00 to 30000.00 Nm
Range: 0 to INT MAX rpm
Range: 0 to 400