Parker AC890 Product Manual page 427

Parameter Descriptions
RATIO
Set the resolver's transformation ratio (at 8kHz, nominal carrier voltage).
SPEED MAX
Set the resolver's maximum mechanical speed in RPM. If unknown, the value must be set to the motor maximum speed.
ACCURACY
Set the resolver's peak to peak accuracy (in minutes). If unknown, use the default value.
CARRIER VOLTAGE
Set the resolver's nominal carrier rms voltage at 8kHz (in Volts). If unknown, use the default value.
CURRENT
Set the resolver's nominal carrier rms current at 8kz under nominal carrier voltage (in Amps). If unknown, use the default value.
INERTIA
Set the resolver's rotor inertia (in kg*cm²). If unknown, use the default value.
POSITION SET UP
The electrical position offset value, in degrees. The value will adapt the resolver to the motor phasing (this parameter is
automatically set up by using the MOT POLARISATION function block). The value could also be entered here if known.
RESOLVER POS OUT
Mechanical position given by the resolver.
TRIP
This is a diagnostic output indicating a resolver trip:
TRIP = FALSE : resolver is OK
TRIP = TRUE : resolver is tripped
D-136
Page
PREF: 133.03
PREF: 133.04
PREF: 133.05
PREF: 133.06
PREF: 133.07
PREF: 133.08
PREF: 133.11
PREF: 133.15
PREF: 133.16
Default: 0.3
Default: 10000
Default: 20.00
Default: 7.00
Default: 0.046
Default: 24.00
Default: 0.00
Default:
Default: FALSE
890SD Standalone Drive - Frames G, H & J
Range:0.15 to 1.0
Range: 0 to 2147483647
Range: 0.00 to 60.00 minutes
Range: 1.00 to 10.00V
Range: 0.000 to 1.000A
Range: 10.00 to
32768.00Kg.cm2
Range: -180.00 to 180.00 deg
Range: _.xxxx
Range: FALSE / TRUE