Parker AC890 Product Manual page 59

890SD Standalone Drive
4.1: Apply the 3-Phase Supply
1. Apply the 3-phase supply to the 890SD Standalone Drive.
2. Select LOCAL mode operation:
♦ The Keypad will display the Remote Setpoint parameter (%).
3. You MUST carry out an Autotune if you intend to use the drive in Sensorless Vector Fluxing Mode
or Closed-Loop Vector Mode - go to page 4-53. If you are using the drive in Volts/Hz Mode (Open-
Loop Drive) an Autotune is not necessary - go to page 4-58.
4-40
Page
Hold the Stop key down until
the display spells
Release the key to display
the previous menu
SETPOINT (LOCAL)
= 0.0%
890SD (Standalone) Drive: Frame G, H & J
REMOTE
LOCAL