Esc+~B Eject And Cut - SATO CL4NX Programming Reference Manual

12.11 System
12.11

ESC+~B Eject and Cut

Eject and Cut
ESC
Hexadecimal
code <1B>
16
Initial value Nil
When the power switch is OFF
Valid range and
term of Valid range within items
command
Valid range between items
[Function]
Specifies eject and cut operation
[Format]
<~B>
[Coding Example]
<A>
<~B>
<Z>
(1) Label stop position
A: Printed
B: Not printed
C: Not printed
D: Not printed
(2) Command received
(3) Label is fed to the cut position.
(4) Label is cut off.
(5) Label is back fed to the print position.
[Supplementary Explanation]
1. Valid only for cutter models.
2. This command is used to cut the last label remaining in the printer.
3. This command <~B> should be used by differentiating between Start code<A> and Stop code<Z>.
4. This command <~B> may not be used in combination with other commands.
5. This command <~B> is valid when the printer still holds the label which is not cut after being printed.
[Note]
This command is used to cut remaining label in printer after the commands <~A>0 or <~>0 is executed.
~B Parameter
<7E> <42> Nil
16 16
The set command is not maintained.
The set command becomes invalid.
The set command becomes invalid.
261
ESC+~B
Feed direction
(1)
(2)
(3)
(4)
(5)