SATO CL4NX Programming Reference Manual page 338

[Valid command]
<X20>
font
<B>
Barcode
<2D10>
[Supplemental explanation]
1. If you specify reading data and start use (<TU>1), specify cancel use (<TU>0) within the same print job if.
2. Only one pair of this command (<TU>1, <TU>0) can be specified in one print job.
3. This command cannot be specified together with sequential printing or registering formats.
4. You cannot specify multiple labels for print jobs that include this command. Even if you specify 2 or more labels
with<Q> command, it will be interpreted as 1.
5. This command cannot be used in combination with other RFID commands.
6. When you specify the user ID by using <DN> in the data part during the use of 2D codes, specify the number of
characters of the user ID in the number of data items.
Example: <TU>1,01000007SATO
<DN>0004,SATO
7. This command will not be executed while the printer is printing. It will be executed after the print is complete.
8. This command is enabled in sequential printing, cutter (behavior 1), dispenser (behavior 2). It cannot be used in
tear-off mode, cutter(behavior 2) and dispenser(behavior 2).
9. This command will not work correctly if the tag offset is set anywhere other than default position.
10. In case if tag data could not be read, error message will be printed and will retry with the next label or discard
depending on the retry/release setting.
11. This command does not support reprinting with reprint command<C>, external reprint signal or reprint button.
12. In case of a command error due to erroneous format of print job that includes this command, printer will not print
label (so as not to waste label) but will ring the buzzer once short to go to OFFLINE. The label will not be printed as
long as the reason of command error is not removed.
13. In case if the settings are made to ignore the sensor, this command will have command error.
14. The only barcode type allowed in <B> (ratio 1:3) and <D>(ratio 1:2) is "1:CODE39".
15. QR code <2D30>, <2D31> are available, but they cannot be specified in numerical mode and Kanji mode. Micro QR
code are not available due to limitations in the number of data.
16. The maximum number of print elements (valid commands that include ID) to be converted for this command is 20.
Avoid exceeding this maximum. When exceeded, the exceeded print element may become erroneous data.
17. For valid command with limited digit number in target data, it is necessary to fill valid command with data if data
obtained from RFID tag do not have enough digit number after it is specified by this command.
Example: <TU>1, 01000003SATO
<BI>020502SATO0
<X21> <X22> <X23>
<BC> <BG> <BI>
<2D12> <2D20> <2D30>
330
<X24> <XM> <XS>
<BZ> <D> <BD>
<2D31> <2D50> <DN>
<XU> <XB> <XL>
<DS>