SATO CL4NX Programming Reference Manual page 436

[Return data]
Symbol Parameter name
Total number of data byte
*This is the total number of bytes after parameter b. The
a
delimiting comma between parameters a and b, and the
ETX are not included.
Identifier
b(e)
Setting information data size
c(f) *Number of bytes of the section unit after parameter d.
The delimiting comma between sections is not included.
Setting information data
d(g)
*Text format
[Setting information data format]
"Setting item name" + ":" + "Setting data" + "Line feed (0DH, 0AH)"
h...h:i...i[CR][LF](j...j:k...k[CR][LF])...
[Setting information data]
Symbol Parameter name
h(j...)
Setting Item name
i(k...)
Setting data
Data Example)
CA,12345,SPEED:4
LEVEL:5
CONCENTRATION:A
[Return data format (when a command error occurs)]
[NAK]<15>
16
[Exception processing]
Parameter name
A value outside the range is specified
Identifier
Command error
Terminology Description
Command error The data received after a command error is determined is not considered as a parameter
of this command.
[Note]
1. When identifiers are omitted, all data will be returned.
2. When setting item names are specified, setting information of the item which was set will be returned.
Host
DC2 + PB...[EOT]
Valid range
Data size from the first identifier
until before [ETX]
CA: Common settings
CB: Warning function
II: IEEE1284 settings
IR: RS-232C settings
IL: LAN settings
IU: USB settings
IW: WLAN settings
IB: Bluetooth settings
IE: EXT settings
IF: RFID settings
SB: SBPL settings
SZ: SZPL settings
SI: SIPL settings
SD: SDPL settings
ST: STCL settings
SA: AEP settings
Size of the corresponding setting
information data
Refer to "Setup information data"
below.
Valid range
Refer to the printer status information list
Refer to the printer status information list
Exception condition
The specified size and received size are different
Invalid receive data
428
Printer