Esc+2D30 Qr Code (Model 2) - SATO CL4NX Programming Reference Manual

10.4 2D code
10.4

ESC+2D30 QR Code (Model 2)

QR Code (Model 2)
ESC
Hexadecimal
code <1B>
16
Initial value Nil
When the power switch is OFF
Valid range and
term of Valid range within items
command
Valid range between items
[Function]
Specifying QR Code (Model 2)
[Format] (Setup part)
<2D30>,a, bb, c, d(,ee, ff, gg)
●Parameter
a [Error Correction Level]
b [Size of one side of cell]
*Specify more than 02 dots when head density is 12dot/mm, otherwise scanner may have reading problem
c [Data setup mode
* Note: You need to change the method of specifying print data with this setting.
d [Concatenation mode]
Following parameter must be specified when specifying 1 (Concatenation mode) in Concatenation mode.
Omit following parameter in normal mode.
e[Number of partitions of concatenation mode]
* Number of partitions: Specifying how many QR code are to be concatenated devided by Concatenation mode.
f[Sequential number partitioned by concatenation mode] =
* Sequential number: Specifying what number is it of devided QR code.
g[Concatenation mode parity data]
* Parity data: Specifying exclusive OR of all the print data in devided QR code with HEX characters.
[Format] (Data part)
Manual setup (Data setup mod)
<DS>k,n~n * Use when input mode specification is Numeric mode, Alphanumeric mode and Kanji mode.
<DN>mmmm, n~n * Use when specifying by binary.
Automatic setup(Data setup mode)
<DN>mmmm, n~n * Change input mode automatically according to input data.
[Format] (Version)
<QV>pp * Use when specifying the version.
●Parameter
k [Input mode] =
* Specify only when specifying Manual setup in Data setting mode.
* There is binary specification other than above, but data specification command is different.
m[Number of data] =
* Specify when specifying Automatic setup in Data setting mode or specifying binary specification in Manual setup.
n [Print data] =
pp[Version] =
*Use when fix the size of QR symbol by specifying the version. When not specified, it will be specified automatically.
It will be Auto when specifying 00. The parameter error doesn't arise in the range from 00 to 40.
*Refer to [QR code version command] for details.
[Supplementary Explanation1]
1. When specifying Kanji in <DN>, specify size that is 2 X number of Kanji characters.
2. For <DN> in Automatic setup, when 80Hto9FH and E0H to FFH are specified as data, it is handed as Kanji mode,
and cannot specify them as binary.
2D30
<32> <44> <33> <30>
16 16 16 16
1 : Numeric mode
2 : Alphanumeric mode
3 : Kanji mode (Shift JIS Kanji)
Valid Range : 1 to 2953
Data
00 to 40 (MODEL2)
169
ESC+2D30
Parameter
,a,bb,c,d(,ee,ff,gg)
The set parameter is not maintained.
The set parameter becomes invalid.
The set parameter becomes invalid.
= L : 7%
M : 15%
Q : 25%
H : 30%
= Valid Range : 01 to 99 dots
= 0 : Manual setup
1 : Automatic setup
= 0 : Normal mode
1 : Concatenation mode
= Valid Range : 01 to 16
Valid Range : 01 to 16
= Valid Range : 00 to FF