SATO CL4NX Programming Reference Manual page 264

【Coding Sample 2】
<A>
<V>100<H>200<P>2<L>0202<XS>ABCD
<Q>2
<EP>,128
<Z>
【Supplementary Explanation】
1. Use this command in the sensor invalid mode.
2. Use this command in combination with Label Size <A1>.
3. When you specify the parameter, the last position of printing + value specified in parameter will be the stop
position of label. However if last position of printing + position specified in parameter exceeds label length, the
size is truncated to label length.
4. If you specify label size <A1> in Format Registration <YS> and Form Overlay Registration <&S> make sure to
specify Print End Position<EP> when you specify Format Call<YR> and Form Overlay Call<&R>.
5. The label stop position depends on the following combination. The table below shows which commands will be
adopted by the combination of <A1>～LCD setting items.
<A1>
Without
parameter
○ ○
○
-
○
-
○ ○
○
-
○
-
- -
- -
○
-
- -
<EP> LCD
setting
With
parameter item
- -
○
-
○
-
○
-
○ ○
- -
○
-
○
-
○
-
○ ○
256
ABCD
Adopted command
<A1>
<EP>
LCD(Print End Position)
<A1>
<EP>
<A1>
LCD(Label Length)
<EP>
LCD(Print End Position)
<A1>
LCD(Label Length)
<EP>
Print stop position
128dot
Label stop position
Remarks
If you do not specify of
the <EP>.
If after power ON, <A1>
is designated once.
If after power ON, <A1>
is not specified even
once.
If you do not specify of
the <EP>.
If after power ON, <A1>
is designated once.
If after power ON, <A1>
is not specified even
once.