SATO CL4NX Programming Reference Manual page 361

Parameters related to specify block to start writing(omissible)
Specify block to start writing
wsb:
Take note that this parameters related to write starting block cannot be used for writing data in NFC(NDEF) format.
Mapping table of IC chip type and number of blocks, and total capacity
IC chip type
00 NTAG203
01 NTAG210
03 NTAG213
04 NTAG215
05 NTAG216
30 MIFARE Ultralight
31 MIFARE Ultralight(EV1)(MF0UL11)
33 MIFARE Ultralight C
62 my-d move NFC
Specifies the block to start writing the data. Block is a unit to write to user
memory. The following values in the table are allowed based on the type of
inlets. A maximum up to 3 digits in decimal can be specified. A parameter
error will occur if it exceeds the maximum amount for the specified inlet.
Please see the following table.
Product Capacity of 1
353
Total number of
block blocks
4bytes 36blocks
4bytes 12blocks
4bytes 36blocks
4bytes 124blocks
4bytes 222blocks
4bytes 12blocks
4bytes 12blocks
4bytes 36blocks
4bytes 32blocks
Total capacity Valid range of
number of
blocks
144bytes 0 to 35
48bytes 0 to 11
144bytes 0 to 35
496bytes 0～123
888bytes 0 to 221
48bytes 0 to 11
48bytes 0 to 11
144bytes 0 to 35
128bytes 0 to 31