SATO CL4NX Programming Reference Manual page 178

[Coding Example1] Error correction level: 7%, Size of one side of cell: 05
Data setup mode: Manual setup, Concatenation mode: Normal
<A>
<V>100<H>200<2D30>,L,05,0,0
<DS>1,012345
<Q>2
<Z>
[Supplementary Explanation2]
1. If the parameter other than the description is specified or number of print data is not match, print is not executed.
2. Data specification command in data part varies according to parameter setup or specified data.
[Coding Example2]Error correction level: 7%, Size of one side of cell: 04
Mixed specification of Manual setup (Data setup mode)
In Manual setup, you can proceed specifying data in specified input mode (Numeric, Alphanumeric, Kanji, Binary).
<A>
<V>100<H>200
<2D30>,L,04,0,0
<DS>3,サトー
<DN>0010,0123456789
<DS>1,123
<Q>1
<Z>
[Supplementary Explanation3]
1. Parameter part to be followed by Data part. Data part and data part should be specified in a row. When don't specify
in a row, print result may not be secured.
2. Total number of data (n) need to be less than 7000 bytes. Maximum number of blocks in data part specified in a row
is 200.
[Coding Example 3] Error correction level: 7%, Size of one side of cell: 05, Data setup mode: Manual setup,
Concatenation mode: Normal, Version 5
<A>
<V>100<H>200<2D30>,L,05,0,0
<QV>5
<DS>1,012345
<DN>0004,6789
<Q>1
<Z>
[Notes]
1. Specify <QV> command between <2Dxx> and <DN>/<DS>.
2. When resulted in a parameter error, it will be handled in the same manner of no specification.
3. It doesn't become a parameter error from 00 to 40. (Set the value within the range corresponding to each model)
For MODEL2, the setting range is from 00 to 40.
4. Sending the data exceeding the data size of specified version will result in error and QR code is not printed.
170