Part 2 Interface Specification; Overview; Combination Of Interfaces - SATO CL4NX Programming Reference Manual

Part 2 Interface Specification

1 Overview

1.1
Overview
The CL4NX printer has two types of interfaces: a built-in interface on the printer to communicate data with host, and an external signal interface
to connect printers and peripheral devices with.
The printer has the following built-in interfaces.
1) USB interface (USB2.0 High speed, type A connector/type B connector)
2) LAN interface (10BASE-T/100BASE-TX auto-detecting, RJ45 connector)
3) RS-232Cinterface (DB9pin (female terminal))
4) IEEE1284 interface (communication mode: ECP mode/compatible, amphenol 36 pin)
5) External signal interface (amphenol 14 pins)
6) Bluetooth interface (Ver.3.0 + EDR Class 2)
The following interfaces are optional.
1) Wireless LAN unit (802.11a/b/g/n)
1.2

Combination of Interfaces

The interfaces can have the combinations shown in the table below.
CONT PCB USB
LAN
KB PCB Bluetooth
NFC
IF PCB RS-232C
(COMBO)
IEEE1284
EXT
Optional Wireless
PCB LAN
[Note]
LAN and WLAN cannot be used together, but LAN or WLAN is selectable from LCD. For details, refer to 6.14 Switching LAN and
WLAN.
CONT PCB
USB LAN Bluetooth
〇 〇
〇 〇
〇 〇
〇 〇 〇
〇 〇 〇
〇 〇 〇
〇 〇 〇
〇 △ 〇
KB PCB
NFC RS-232C
〇 〇
〇 〇
〇 〇
〇
〇
〇 〇
〇 〇
〇 〇
485
IF (COMBO) PCB
IEEE1284 EXT
〇 〇
〇 〇
〇 〇
〇 〇
〇 〇
〇
〇
〇 〇
[○: configurable, X: not configurable]
Optional PCB
Wireless LAN
〇
△
〇
〇
〇
〇
〇