Esc+Ep Print End Position - SATO CL4NX Programming Reference Manual

12.6 System
12.6

ESC+EP Print End Position

Print End Position
ESC
Hexadecimal
code <1B>
16
Initial value Nil
When the power switch is OFF
Valid range and
term of Valid range within items
command
Valid range between items
[Function]
Specifying the label stop position in the sensor ignored mode.
[Format]
<EP>[,aaaaa]
●Parameter
「print stop position」
a
【Range of specification】
Model
203dpi
CL4NX 305dpi
609dpi
203dpi
CL6NX
305dpi
[Coding Example]
<A>
<A1>014240832
<Z>
<A>
<V>100<H>200<P>2<L>0202<XS>ABCD
<Q>2
<EP>
<Z>
Example
) 8dot/mm, 12dot/mm
ABCD
[Supplementary Explanation]
1. Use this command in the sensor invalid mode.
2. Use this command in combination with Label Size <A1>.
3. After using <A1> command for <YS> and <&S> command, it needs to use <EP> command when specifying<YR>
and <&R>.
EP Parameter
<45> <50> [,aaaaa]
16 16
The set command is not maintained.
The set command becomes invalid.
The set command becomes invalid.
= Refer to the following table
Length of label(dots)
0 to 20000
0 to 18000
0 to 9600
0 to 20000
0 to 18000
Start point
1
Stop position without
command <EP>
Stop position with
command <EP>
255
ESC+EP
1
104mm
832 dots
(1248 dots)
Value inside ( ) is 12 dots/mm
1249mm
9992 dots
(14988 dots)