Tag Mode; Data Format - SATO CL4NX Programming Reference Manual

10.2 Tag mode

This mode works when printer is turned off.
It reads and writes on NFC tag memory (888 bytes).
It writes printer information to the NFC tag memory when printer is switched off. This information can be obtained.
When you write, NFC tag memory information is sent to the printer when the printer is turned on.
Purpose: Printer Settings, Collect information
Note: Device information should be read before writing, since the read and write uses the same area.
800 bytes are available as the valid area for NFC tag memory.

10.2.1 Data format

1. Transmission data format
Sets transmission data with zlip compression.
The maximum size is 800 bytes after compression.
2. Receive data
The receive data is an uncompressed text data.
Settings
Device
information
Transmission data after compression
Receive data
590