SATO CL4NX Programming Reference Manual page 451

Hide thumbs Also See for CL4NX:

Table of Contents

[Supplemental explanation]

1. This command cannot be used in combination with commands other than <A> and <Z>.

2. When this command is received during printing, it will not be processed. It will be processed after printing is

3. It takes about 5 seconds to return all return status to the host after sending this command. If the port is disconnected

before all statuses are returned to the host, RFID tag information will not be correctly returned and the data other

than return status format is returned.

4. After sending this command, do not send the next command or data until all status replies are returned to host.

5. When this command turns into an error, it will return "EPC_Tag_Err" in Ascii.

6. When the communication protocol is used only for driver or set to Status 3, ACK/NAK is returned before status reply

after this command is sent.

7. This command is available when printer is in continuous mode and cutter mode (motion 1), and dispenser mode

It is not available when in tear-off mode, cutter mode (motion 2) and dispenser mode(motion 2).

8. This command will not work properly when tag offset is set anywhere other than default position.

9. In case where lower power consumption mode is valid, [NAK] is returned until printer does wake up.

a...a,b...b(,c...c)

(,aa)(,aa)(,aa)