Switching Between Lan And Wlan - SATO CL4NX Programming Reference Manual

Hide thumbs Also See for CL4NX:

Table of Contents

6.14 Switching between LAN and WLAN

This is a function that switches between interfaces so that you can use a LAN when a WLAN unit is connected.

Go to Interface > Network > Interface on the LCD screen and select the interface to be used.

Any of following 3 items can be selected:

To enable the changed setting, restart the printer after you make the change.

Note that besides using the LCD screen, you can also change the setting with the DC2 command. (Refer to

"Command Specification" for details.)

[Restrictions]

1. If the "Wi-Fi" setting is selected and you disconnect the WLAN unit before starting up the printer, the setting

changes to "AUTO".

2. Other than the MAC address, the network settings for the LAN and WLAN are the same (DHCP/STATIC, IP address,

subnet mask, gateway address, etc.).

If a LAN cable is connected when the printer is started up, the LAN is enabled. If

the printer cannot detect a connected LAN cable, the WLAN is enabled.

The LAN is enabled, and the WLAN is disabled.

The WLAN is enabled, and the LAN is disabled.