Eject Cut; Darkness Range - SATO CL4NX Operator's Manual

Backfeed
Printing > Backfeed
Backfeed is applicable only when the print mode is set to tear-off mode,
cutter mode, dispenser mode or linerless mode (CL4NX only).
The options are as follows:
• None: Do not backfeed.
• After: After cut, backfeed the front part of the next media to the print
head position. For dispenser mode, backfeed the front part of the next
label after dispensing the label.
• Before: Before printing, backfeed the front part of the media to the print
head position.
If you have selected Tear-Off or Linerless (CL4NX only) in Print Mode,
only Before is available in the Backfeed menu.

Eject Cut

Printing > Eject Cut
Set the Eject cut motion for the last printed media. Cut the last media after
the specified timing.
Shows only when you have selected Cut & Print in the Print Mode menu.
The setting range is from 0 to 5 (sec).

Darkness Range

Printing > Darkness Range
The darkness range affects the print darkness.
The options are as follows:
A, B, C, D, E, F
*The normal setting is A. You can also select B to F but the print darkness
does not change.
4 Operation and Configuration
CL4NX/CL6NX Operator Manual
79