Nfc; Basic Specifications - SATO CL4NX Programming Reference Manual

10 NFC

10.1 Basic Specifications

Interface
Communication distance
Communication settings
Print mode
Communication timeout
NFC receive buffer size
Size of receive buffer
[Additional notes]
The NFC interface of this printer uses NXP Semiconductors NT3H1101.
Does not support 1-byte command(status response).
NFC allocation on printer
Note
This feature is supported on printers from serial number 6B~ and above.
NFC forum Type 2 Tag compliant
If height is 0mm from Antenna center, communicates within ±5mm to the right
and left.
If height is +10mm, communication distance is within ±10mm to the right and
left.
No communication settings.
Module is automatically detected after factory clear.
Can be enabled/disabled in Service mode (module behavior) and Interface
mode (communication behavior)
When power is OFF: Tag mode (NDEF format write to NFC tag) by tag mode
When power is ON: Passthrough mode, Bluetooth/WiFI handover connection
1 second
Tag mode: 888 bytes(the whole NFC tag memory)
Pass through mode: 51,200 bytes
*Note: This is the maximum communication size with pass through mode.
e.g.) Pass through mode communicates with 50 KB or less for one packet.
(NG(fail) is returned if more than 50 KB. The received data is discarded in this
case.)
2.95MB
0MB
Near full
occurred
Nearfull
cleared
589
2.95MB
0.95MB remaining
1.95MB remaining