Return Status Of Status 4 - SATO CL4NX Programming Reference Manual

2.2.2 Return status of status 4

The printer returns its status and reply as the status upon receiving four types of request commands and print command with this
communication protocol.
Details of request commands and return status are described below.
1) Status request command
The printer returns the job ID number of receive data that is currently printing, the printer status and the number of remaining labels to print
to the host by receiving this command. When the print is completed or when there is no receive data, the printer returns print quantity of all
"0" (HEX 30H).If the command for the designation of job ID number <ID> is not specified, the printer returns the space (HEX 20H) as the
ID number.
Avoid sending ENQ while sending the print data (STX <A> - <Z> ETX). This may cause return status error or print error.
(1) Command ENQ (HEX 05H)
(2) Return status format
Number of
transmission bytes
4 bytes
00000020H
Number of
Transmission bytes
4 byte
0000001CH
Number of ENQ
transmission bytes
1byte
4 bytes
05H
0000001CH
ENQ STX ID
number
1 byte 1 byte
05H 02H 2 byte
The ID no. specified with Job ID specification
command is set.
STX ID
number
1 byte
02H 2 byte
STX ID No. Status
1byte 2bytes 1byte
02H
Status
Number of
1 byte
Remaining label
6 byte
000000～999999
Status Remaining
print number
1 byte
6 byte
492
LAN, Wireless LAN 36 bytes LAN
Legacy Status setting is valid.
No. of JOB
Remaining
name
labels
16bytes
6bytes
JOB ETX
name
1 byte
s
03H
16 byte
The JOB name will be set
by the JOB name specify command.
JOB ETX
name
1 byte
16 byte 03H
ETX
1byte
03H
LAN, wireless LAN
32 byte
Legacy Status for
Port9100 Disable
Interfaces
other than above
27 byte
16 byte