SATO CL4NX Programming Reference Manual page 390

Parameters related to write block list (omissible)
Write block list
blt:
Parameters related to subtraction register (omissible)
Specify the subtraction register
rga:
A.
Specify the subtraction register
rgb:
B.
Specify the subtraction register
rgc:
C.
※1: When writing a value larger than the original data in subtraction register A or B, VERIFY TAG ERR error will
occur.
It is possible to write to block of uncontinuous data when specifying a block
list format which block number is delimited by comma.
The scratch pad (user area) of FeliCa Lite/FeliCa Lite-S comprises 14 blocks,
each block can be specified to 0 ~ 13.
The number of the block list is calculated as 16 bytes per block, with the
condition that the data length specified by D (or d) parameter fulfills the
following relation:
number of the block list = specified data length ÷ 16
(+1 if there is remainder)
For example, if the data length specified by D (or d) parameter is 52 bytes,
although 52÷16＝3, the number should be 3+1=4 as there is remainder.
If 52 bytes are divided into 4 sets of 16 byte and write the data to each 0, 2, 8,
13 block, specify as blt:0,2,8,13.
In the 4th block, the area after the remaining data will be filled with NULL.
E.g.:
<A>
<RK>4,D52,ABCDEFGHIJKLMNOPQRSTUVWXYZabcdefghijklmnopqrstuv
wxyz,blt:0,1,8,13
<Z>
The scratch pad data after executing the example above
Block number
0
1
：
8
：
13
Note 1: The ････ area is written with NULL.
Note 2: No change to the data which block is not specified.
Note 3: This data is an example for describing RFID command output.
Cannot be used together with wsb:.
Cannot be used together with parameters related to NFC(NDEF).
Set a decimal from 0~4,294,967,295.
The register value for inlet shipping is 4,294,967,295.
Write is possible only when the setting value is below the value stored in the
（※1）
register.
Set a decimal from 0~4,294,967,295.
The register value for inlet shipping is 4,294,967,295.
Write is possible only when the setting value is below the value stored in the
（※1）
register.
Set a fixed 16-digit hexadecimal. Specify an even number for the number of
digit.
The hexadecimal for inlet shipping is FFFFFFFFFFFFFFFF.
This register without subtraction function is regarded as normal memory.
382
Data after write
ABCD EFGH IJKL MNOP
QRST UVWX YZab cdef
：
ghij klmn opqr stuv
：
wxyz ････ ････ ････