SATO CL4NX Programming Reference Manual page 170

[Supplementary Explanation]
1. Base print position of PDF417 is specified by vertical print position<V> and horizontal print position<H>
<V>100<H>200<2D10>***・・・・・・**
2. When d=e=00, aspect ratio will be at 1:2 based on the number of print data.
3. When parameter d and e doesn't match number of data, print may not be performed properly.
4. When specifying security level height, parameter d or e should have large number.
5.Recommended to specify more than 2 dots for 8 dots/mm and 12 dots/mm printhead, and 4 dots for 24 dots/mm
printhead because the minimum module width and minimum module height of QR code may not be read by the
scanner.
6.Created module was modified to improve the quality. The module may be different from the previous one, but the
read result is the same.
[Point]
1. Sequential number is not available.
2. Specifying print position by automatic line feed is not available.
3. Print 00HtoFFH is available.
4. Format registration is available.
5. Enlarging minimum module size improves print quality.
6. Increasing security level improves read rate.
7. Print height varies depending on the character such as numeric only, alphabet only or mixture of numeric and
alphabets.
200
100
162