SATO CL4NX Programming Reference Manual page 48

[Coding Example] Font's alignment position: Top Right, barcode alignment position: Bottom left
<A>
<AL>3
<V>100<H>700<P>3<L>0403<X22>,ABCD
<AL>7
<V>400<H>200<BD>103160*123*
<Q>2
<Z>
[Supplementary Explanation]
The alignment position will ignore anything that was set, and sets the default "Top left" if the value for parameter
1.
a was 0 or a non-numeric value.
2. If you select Middle or Bottom, the position may vary depending on the ascender line and descender line of each
field. Ascender/descender lines depend on each font, so not all fonts may show like in the examples as below.
E.g.) Cases with and without 'ĺ' and 'g'
HHH
HĺH
3. Make sure to specify <H> and <V> to the field when you select Center and Right. If they are not specified when
specifying for the 2
which means that the parts of the 1
E.g.) If <H> and <V> are not specified to the 2
Center
Left
Left
ABC DEF
E.g.) If <H> and <V> are not specified to the 2
Center
Left
Center
Left
ABC DEF
Printer does not print if the positions specified with <H> and <V> (equal to "Alignment position") if they are out of
4.
printable range.
Top
Middle
Bottom
Top
Middle
Bottom
nd
field, the trailing edge of the 1
st nd
and 2 field will overlap.
nd
Right
Right
Center
nd
Right
Right
<V>100<H>700
ABCD
<V>400<H>200
HHg
Hĺg
st
field becomes the base reference point of the 2
field when specifying Center
field when specifying Right
40
Top
Middle
Bottom
Top
Middle
Bottom
nd
field,