SATO CL4NX Programming Reference Manual page 381

[Coding sample 9]( data format set to ASCII)
In case where 13 bytes characters of [4912345678904] is recorded to RFID tag of NTAG215 from a block of user
memory 12 and target block is locked simultaneously (lock L and BL at the same time), with "Ignore RFID tag error"
omitted
<A>
<V>50<H>50<BD>3020654912345678904
<RK>1,D13,4912345678904,ict:04,wsb:12,dlk:010001
<Q>2
<Z>
Memory data after execution
Block
0 1 2 3 4...15
Data
[Supplemental explanation]
1． This command allows to print for continuous printing, cutter printing, dispenser printing and tear-off.
2． This command cannot be specified multiple times in between <A>(start of data transmission) through <Z>(end of
data transmission).
3． Contents of sequential printing or calendar cannot be written as information to the tag.
4． The sent information and written information are verified before printing when information is written to tag with this
command.
5． The default value of parameter b is 0 (stop without ignoring tag error).
6． If printing object doesn't exist for the print job that includes this command, printer only writes for RFID and doesn't
feed label. The buzzer will sound 6 times if it fails to write to tag. If successful, the buzzer is sounded 2 times but
does not feed the label. If you want to feed or print as blank label specify 1 for the "fsw: feed without printing" field.
7． Refer to the following chart if you want to specify the alphabet "A" in ASCII/HEX data formats.
specify the block to start writing with wsb:
Refer to "ISO/IEC14443 Type A memory structure"
16 17 18 19
4912 3456 7890 4XXX
Becomes Read only with dlk:
Mode ASCII
Data 'A'
Code 41H
20...31 32...47
Data in the byte
position outside for
writing is
maintained.
*XXX is the data existed before the write.
dlk: disables Read only
HEX
"41"
34H,31H
373
48.....129 130 131 132 133 134