Removing The Control Panel Unit - Canon ImageRunner iR8500 Series Service Manual

Chapter 11
[4]
[3]
When mounting, be sure to match the marking [7] of the control panel
harness against the wire saddle at the rear.
10) Remove the 2 RS tightening screws [1], and detach the original
delivery tray [2].
[1]
11) Open the toner cartage [1], and remove the 3 RS tightening screws
[2]; then, while paying attention to the claw [4], detach the upper
right cover [3].
11-30
[5]
[4]
[1]
[5]
[6]
[7]
[1]
[2]
F-11-58
[2]
F-11-59
[1]
12) Remove the 6 RS tightening screws [1]; then, while paying attention
to the claw [3], detach the lower arm [2].
[1]
13) Open the 2 edge saddles [1], and pull out the control panel harness
[3] from the lower arm [2].
[3]

11.5.13.2 Removing the Control Panel Unit

/ iR8070
1) Remove the inside upper cover
2) Remove the screw [1], and detach the left upper cover (small) [2].
[2]
[3]
[4]
F-11-60
[2]
[1]
[3]
F-11-61
[1]
[2]
F-11-62
0008-8239