Mounting The Manual Feed Roller; Manual Separation Roller; Removing The Separation Roller - Canon ImageRunner iR8500 Series Service Manual

Chapter 9
4) Remove the E-ring [7], spacer [8], and bearing [9] at both front and
rear; then, detach the manual feed roller [10].
[10]
[9]

9.10.8.4 Mounting the Manual Feed Roller

iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Set the manual feed roller assembly to the main body.
2) Mount the rear fixing plate 2 and the rear fixing plate 1 in the order
indicated; then, secure them in place with the mounting screw [3].
9-62
[6]
[5]
[4]
F-9-110
[8]
[7]
F-9-111
0007-1244
Rear fixing plate 2
F-9-112
When mounting the manual feed roller, hook the two claws of the rear
fixing plate 2 on the three holes in the rear side plate; then, mount the
rear fixing plate 1 to secure.
3) Secure the front fixing plate [4] with two screws [5].
[4]
[5]

9.10.9 Manual Separation Roller

9.10.9.1 Removing the Separation Roller

iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Remove the two mounting screws [1], and detach the separation roller
support plate [2].
2) Remove the joint [3], and detach the separation roller [4].
[3]
[1]
When removing the separation roller, pay attention to the bushing at the
front.
It will slip off.
Initially, the urethane sponge of the part is pink, and changes over time
(accelerated if exposed to light).
Its tone will change from pink to orange and to yellow; it is a general
characteristic of urethane sponge, and no physical deterioration (in
performance) exists because of changes in color, and the part is not
identified by color.
F-9-113
0007-1284
[2] [4] [1]
F-9-114