Changing The Paper Size For The Front Deck (Right, Left) - Canon ImageRunner iR8500 Series Service Manual

Chapter 2
interleaf mode or otherwise is a high copy volume user, change the
following service mode settings:
COPIER>OPTION>BODY>TEMP-TBL (Level 2)"5"(Default)->"0"
MEMO:
Starting Service Mode (Level 2)
-Press the Additional Function key.
-Press the 2 and 8 keys on the keypad at the same time.
-Press the Additional Function key.
Press the Additional Function key and the 2 key in succession.
29) Clean up the area around the copier.
30) Move the copier to its final location, and secure it in place using the
adjusters.
31) If you are installing options, do so by referring to the Installation
Procedure that comes with each option.
MEMO
For the Card Reader-D1, see "Installing the Card Reader-D1."
32) Fill out the Service Sheet.
2.2.43 Changing the Paper Size for the Front Deck
(right, left)
iR105i/iR105+ / iR9070
1) Press the release button, and slide out the deck.
2) Remove the screw [1] of the rear end guide plate [2], and secure the
guide plate [2] to the desired position.
[1]
3) Remove the screw [1] (1 pc. each) from the left and right of the guide
plate [2], and secure the guide plate [2] to the desired position.
[2]
4) Put paper in the deck.
5) Slide the deck inside the copier.
6) Peel off the appropriate deck size label [1] from the size label liner
(cassette/deck), and attach it on the paper size plate of the deck.
2-48
0007-6745
[2]
F-2-196
[1]
F-2-197
[1]
7) Start service mode, and register the paper size of the front deck.
MEMO
Right deck : COPIER>OPTION>CST>P-SZ-C1
Left deck : COPIER>OPTION>CST>P-SZ-C2
A4=6,B5=15,LTR=18
8) Thereafter, turn off the main power switch.
Points to Note When Turning Off the Main Power Switch
1. Hold down the control panel power switch for 3 sec or more.
2. Go through the instructions for the shut-down sequence shown on
the display so that the main power switch may be turned off.
3. Turn off the main power switch.
9) Turn on the main power switch.
2.2.44 Changing the Paper Size for the Front Deck
(right, left)
/ iR85+
1) Press the release button, and slide out the deck.
2) Remove the screw [1] of the rear end guide plate [2], and secure the
guide plate [2] to the desired position.
[1]
3) Remove the screw [1] (1 pc. each) from the left and right of the guide
plate [2], and secure the guide plate [2] to the desired position.
[2]
F-2-198
0007-3519
[2]
F-2-199
[1]
F-2-200