Inverter Cooling Fan; Removing The Inverter Cooling Fan (Fm9); Pre-Transfer Charging Assembly Fan; Removing The Pre-Transfer Charging Assembly Fan (Fm10) - Canon ImageRunner iR8500 Series Service Manual

Chapter 11
2) Remove the 2 screws [1], and disconnect that connector [2]; then,
detach the drum fan unit [3].
[3]
[2]
3) Disconnect the connector [1], and remove the 3 screws [2]; then,
detach the drum fan [3].
[2]
[1]

11.5.34 Inverter Cooling Fan

11.5.34.1 Removing the Inverter Cooling Fan (FM9)

iR105i/iR105+ / iR9070
1) Remove the rear cover.
2) Remove the rear upper cover. (2 screws)
3) Remove the screw [1], and detach the inverter cooling fan duct [2].
[2]
4) Remove the 2 screws [1], and slide out the inverter fan [2].
11-46
[1]
[1]
F-11-144
[2]
[3]
F-11-145
0007-3055
[1]
F-11-146
[2]
[1]
When mounting the fan, be sure that the direction of air current is as
indicated by the arrow.
5) Disconnect the connector [1], and detach the inverter cooling fan [2].
[1]

11.5.35 Pre-Transfer Charging Assembly Fan

11.5.35.1 Removing the Pre-Transfer Charging Assembly
Fan (FM10)
iR105i/iR105+ / iR9070 / iR8070
1) Remove the process unit cover. (4 screws)
2) Remove the 2 screws [1], and disconnect the 2 connectors [2]; then,
detach the fan motor [3].
[1]
3) Disconnect the connector [1], and remove the 2 screws [2]; then,
detach the pre-transfer charging assembly fan [3].
[1]
F-11-147
[2]
F-11-148
0007-3057
[2]
[3]
F-11-149