Installing The Card Reader-D1 - Canon ImageRunner iR8500 Series Service Manual

Chapter 2
15) Using the screw [1] removed in step 10, mount the card reader case to the machine.
Take care not to trap the harness indicated with a dashed line.
16) Mount the inside upper cover (Use the 5 screws, and connect the 2 connectors that have previously been removed).
17) Mount the process cover unit (4 screws).
18) Attach the primary charging assembly cover (1 screw).
19) Close the toner cartridge cover.
20) Put back the fixing/feeding unit, and set the fixing/feeding assembly lever.
21) Close the front cover.
22) Connect the copier's power plug, and turn on its main power switch.

2.5.6 Installing the Card Reader-D1

iR105i/iR105+ / iR9070
1) Start service mode, and make the following selections: COPIER>FUNCTION>INSTALLATION>Card.
Enter the lowest of the numbers of the cards to use (1 through 2001).
As many as 1000 cards starting with the number you entered my be used.
2) Turn off the main power switch.
Points to Note When Turning Off the Main Power Switch
1. Hold down the control panel power switch for 3 sec or more.
2. Go through the instructions for the shut-down sequence shown on the display so that the main power switch may be turned off.
3. Turn off the main power switch.
4. Disconnect the power cable (from the wall outlet).
3) Open the front cover.
4) Remove the screw [1], and detach the primary charging assembly cover [2].
5) While supporting the card reader base [1], remove the screw (w/ washer) [2].
(You will need the screw and the washer later.)
2-64
[1]
F-2-233
[2]
[1]
F-2-234
0007-6761