Position Of The Deck (Left) Pickup Solenoid (Sl8); Position Of The Cassette 3/4 Pickup Solenoid (Sl9/10) - Canon ImageRunner iR8500 Series Service Manual

Chapter 14
plate is 34.0 -/+ 0.5 mm when the plunger of the pickup roller releasing
solenoid is drawn (as occurring when [1] and [2] are operated as shown).
(After adjustment, make sure that the distance between the paper face
and the A roller is 2.5 -/+ 0.5 mm when the A roller is in UP position.)
[2]
[2]
A
View from A
14.8.28 Position of the Deck (right) Pickup Solenoid
(SL7)
/ iR85+ / iR8070
Adjust the position using the screw [1] so that when [1] and [2] in the
following figure are operated and the plunger of the pickup roller
releasing solenoid is pulled, the distance from the bottom of each pickup
unit to the bottom edge of the bushing of the roller support plate is 34.5
±0.5 mm.
[2]
[2]
A
View from A
14.8.29 Position of the Deck (Left) Pickup Solenoid
(SL8)
iR105i/iR105+ / iR9070
Use the screw [3] so that the distance from the pickup unit bottom face
to the bushing bottom edge of the A roller support plate is 49.5 -/+ 0.5
mm when the plunger of the pickup releasing solenoid is drawn (as
occurring when [1] and [2] are operated as shown). (After adjustment,
make sure that the distance between the paper face and the A roller is 2.5
-/+ 0.5 mm when the A roller is in UP position.)
14-66
[1]
[1]
[3]
F-14-158
0008-8415
[1]
[1]
[1]
F-14-159
0007-0645
[2]
[2]
A
14.8.30 Position of the Deck (left) Pickup Solenoid
(SL8)
/ iR85+ / iR8070
Adjust the position using the screw [1] so that when [1] and [2] in the
following figure are operated and when the plunger of the pickup roller
releasing solenoid is pulled, the distance from the bottom of each pickup
unit to the bottom of the bushing of the roller support plate is 50 ±0.5
mm.
[2]
[2]
A
View from A [1]
14.8.31 Position of the Cassette 3/4 Pickup Solenoid
(SL9/10)
iR105i/iR105+ / iR9070
Use the screw [3] so that the distance from the pickup unit bottom face
of each cassette holder and the bushing bottom edge of the A roller
support plate is 35.5 -/+ 0.5 mm when the plunger of the pickup roller
releasing solenoid is drawn (as occurring when [1] and [2] are operated
as shown). (After adjustment, make sure that the distance between the
paper face and the A roller is 2.5 -/+ 0.5 mm when the A roller is in UP
position.)
[1]
[1]
[3]
View from A
F-14-160
0008-8417
[1]
[1]
F-14-161
0007-0647