Canon ImageRunner iR8500 Series Service Manual page 167

6) Push in the face plate [1] lightly, and take out the card reader base assembly [2] from below.
7) Remove the 2 screws [1], and detach the face plate [2] from the card reader base assembly [3].
(You will use the removed parts later.)
8) Remove the 2 screws that remain on the top of the card reader [1].
Mount the card reader [2] using the 2 removed screws [3] and the 2 screws [4] used to keep the face plate in place.
(At this time, be sure to route the harness [5] and the grounding wire [6] under the card reader as indicated.)
Route the harness through the edge saddle [7].
[1]
[2]
F-2-235
[2]
[1]
F-2-236
[2]
[1]
[1]
[3]
F-2-237
Chapter 2
2-65