Removing The Original Size Sensor; Removing The Original Size Sensor 3/4 - Canon ImageRunner iR8500 Series Service Manual

Chapter 5
[1]
4) Disconnect the connector [1] (1 pc. each), and detach the original size
1/2 [2].
[2]

5.4.13.2 Removing the Original Size Sensor 1/2

1) Remove the copyboard glass.
2) Move the No. 1 mirror base to the right edge.
3) Remove the 2 screws [1], and disconnect the connector [2]; then,
detach the original size sensor unit (front) [3].
[1]
4) Disconnect the connector [1] (1 pc. each), and detach the original size
sensor 1/2 [2].
5-44
[3]
[2]
F-5-133
[2]
[1]
F-5-134
0008-8020
[3]
[2]
F-5-135
[2]
5.4.13.3 Removing the Original Size Sensor
/ iR8070
1) Remove the copyboard glass.
2) Move the No. 1 mirror base to the left end.
3) Remove the screw [1], and disconnect the connector [2]; then, free the
cable from the cable clamp [3], and detach the original sensor unit
[4].
[1]
[5]
When removing the original sensor, take care not to damage it against
the cable [5].

5.4.13.4 Removing the Original Size Sensor 3/4

iR105i/iR105+ / iR9070
1) Remove the copyboard glass.
2) Move the No. 1 mirror base to the left edge.
3) Remove the screw, and disconnect the connector [2]; then, detach the
original size sensor unit (rear) [3].
[2]
[1]
F-5-136
0008-8063
[4]
[2]
[3]
F-5-137
0007-2547