Canon ImageRunner iR8500 Series Service Manual page 798

Chapter 16
Code
E000
E001
E002
E003
E004
E005
E010
E012
E013
E014
E015
E019
E020
E025
E032
E043
E051
E065
E067
E068
E069
E100
E110
E111
E121
E202
E204
E211
E215
E218
E219
E220
E222
E240
E241
E243
E251
E302
E315
E320
E400
E402
E404
E405
E410
E412
E420
E602
E604
E609
E610
E710
E711
E712
E713
E717
E719
E730
E732
16-2
Description
The temperature of the fixing assembly is abnormally high.
The over-rising in temperature of the fixing assembly is detected.
The rise in temperature of the fixing assembly is faulty.
The fixing temperature is too low after a standby state.
The fixing assembly is faulty.
The absence of the fixing web is detected.
The rotation of the main motor is faulty.
The rotation of the drum motor is faulty.
The lock of the waste toner feed screw is detected.
The rotation of the fixing motor is faulty.
The rotation of the pickup motor is faulty.
The waste toner case is full, or the waste toner case full sensor is faulty.
The difficulty providing toner inside the hopper developing assemblies is detected.
The toner feed motor inside the hopper is faulty.
The counter of the copy data controller or the NE controller is faulty.
The rotation of the side paper deck main motor is faulty.
There is an error in the detection of the horizontal registration home position.
There is an error in the high-voltage output to the primary charging assembly.
There is an error in the high-voltage output.
There is an error in the high-voltage output to the separation charging assembly.
There is an error in the high-voltage output to the transfer charging assembly.
The BD PCB is faulty.
The rotation of the laser scanner motor is faulty.
The rotation of the laser motor cooling fan is faulty.
The rotation of the laser cooling fan (1/2) is faulty.
There is an error in the detection of the scanner home position.
There is an error in the detection of the image leading edge signal.
The rise in temperature of the scanning lamp heater is faulty.
The temperature of the scanning lamp heater is abnormally high.
The scanning lamp is not mounted properly.
The scanning lamp life
The lighting of the scanning lamp is faulty.
The rise in temperature of the scanning lamp heater is faulty.
The communication between the MCON and DCON is faulty.
The communication between the original orientation detection PCB and RCON is faulty.
The communication between the control panel PCB and MCON is faulty.
The rotation of the inverter cooling fan is faulty.
Shading error
There is an error in image data.
The reader controller PCB is faulty. The main controller PCB is faulty.
There is a time out error in the image reading processing.
Communication error with the ADF
The rotation of the ADF belt motor is faulty.
The rotation of the ADF delivery motor is faulty.
The rotation of the ADF separation motor is faulty.
The rotation of the ADF pickup motor is faulty.
The rotation of the ADF cooling fan is faulty.
The EEPROM is faulty. The ADF controller PCB is faulty.
There is an error on the hard disk.
The image memory is faulty or is inadequate.
There is an error on the HDD.
The HDD coding key is faulty.
There is an error in the initialization of the IPC.
There is an error in the IPC communication.
Communication error with the ADF
There is an error in the communication with the finisher.
There is an error in the communication with the NE controller.
There is a coin vendor error.
There is a PDL software error.
There is an error in the communication with the scanner.
T-16-1