After mounting the cleaning blade, rotate the drum; if the toner is not colleted by the cleaning blade, repeat the foregoing steps. If it is not corrected after

tightening the screws once again, replace the cleaning blade.

13.3.10 Scheduled Maintenance Work Procedure

0008-8636

/ iR8070

Perform the steps shown for scheduled maintenance work around the drum:

Work Procedure 1

a. Cleaning the Side Scraper

b. Cleaning the Toner Pan

During the work, take care not to rotate the magnet roller drive assembly; otherwise, waste toner may fall out of the cleaner assembly.

1) Slide out the process unit.

Be sure to place the Paper over the fixing/feeding unit.

2) Take out the photosensitive drum.

3) Remove the magnet blade assembly.

4) Using a piece of paper [3] or the like, move the waste toner collecting at the front of the magnet roller [1] and the scraper [2] toward the rear of the

feedscrew.

[2]

[3]

[1]

F-13-40

5) Release the lock of the slide rail, and slide out the fixing/feeding unit farther toward the front.

13-41

Table of Contents