Chapter 9
9.10.20.6 Removing the Reversing Flapper Solenoid
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Remove the duplexing unit from the main body.
2) Remove the two screws [1], and disconnect the connector [2]; then,
detach the reversing flapper solenoid [3].
[2]
9.10.20.7 Removing the Duplex Right Feed Motor
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Remove the front cover of the duplex unit. (4 screws, 3 knobs)
2) Loosen the screw [1]; then, while pulling the tension support plate [2]
in the direction of the arrow, tighten the screw [1] (to loosen the
tension of the belt [3]).
3) Disconnect the connector [4], and remove the 2 screws [5]; then,
detach the duplex right feed motor [6].
[3]
9.10.20.8 Removing the Left Deck Feed Sensor
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Slide out the duplex unit assembly.
2) Remove the screw [1], and detach the sensor base [2].
9-74
0007-1416
[1]
[1]
[3]
F-9-178
0007-2874
[5]
[6]
[1]
[5]
[4]
[2]
F-9-179
0007-2875
[2]
3) Disconnect the connector [1], and free the claw to detach the left deck
feed sensor [2].
[2]
When removing the scanner sensor, be sure to remove the paint used to
lock the claw in place in advance to prevent breaking the claw. When
mounting it, be sure the claw is not displaced or the sensor is not
disoriented.
9.10.20.9 Removing the Horizontal Registration Motor
iR105i/iR105+ / iR9070 / iR85+ / iR8070
1) Remove the duplexing unit from the main body.
2) Remove the two screws [1], and detach the upper cover [2].
3) Disconnect the connector [3], and remove the screw [4]; then, detach
the horizontal registration motor [5].
[1]
F-9-180
[1]
F-9-181
0007-1422
[1]
[2]
F-9-182