Canon ImageRunner iR8500 Series Service Manual page 938

Chapter 17
Sub-item
PNCH-HLE
17-94
Use it to adjust the punch hole position (paper feed direction) when the puncher unit is
used.
<Setting range> -23 to 23 (unit: about 0.5 mm)
<Using the Mode>
1) Make a print of the Test Chart, and check the position of the holes.
2) Select the item, and change the setting to adjust.
3) Press the OK key.
4) Make a print of the Test Chart once again, and check to see if the position of the holes
is as indicated.
Paper
Feed
direction
Lower value
Higher value
Description Level
1