Canon ImageRunner iR8500 Series Service Manual page 996

Chapter 17
Sub-item
SMTPTXPN
SMTPRXPN
POP3PN
RUI-DSP
ORG-LGL
ORG-LTR
UI-BOX
UI-SEND
UI-FAX
UI-EXT
NW-SPEED
TRY-CHG
STS-PORT
17-152
COPIER > OPTION > BODY
Description
Use it to change the number of the SMTP transmission port:
<Setting value>
0 to 65535 (in increments of 1)
Default: 25
After a change, be sure to re-boot the machine.
Use it to change the number of the SMTP reception port.
<Setting value>
0 to 65535 (in increments of 1)
Default: 25
After a change, be sure to re-boot the machine.
Use it to change the number of the P0P3 reception port:
<Setting value>
0 to 65535 (in increments of 1)
Default: 110
After a change, be sure to re-boot the machine.
Setting whether to display a copy screen for RUI (Option switch conforming
to the Disability Law)
<Setting value>
0: Do not display [Default]
1: Display
Use it to set the size of a special paper type not recognized by the feeder.
<Setting value>
0: LEGAL (default)
1: FOOLSCAP
2: M-OFFICIO
3: A-FOOLSCAP
4: FORIO
5: G-LEGAL
6: OFFICIO
7: E-OFFICIO
8: A-OFFICIO
9: B-OFFICIO
10: A-LEAGAL
Use it to set the size of a special paper type not recognized by the feeder.
<Setting value>
0: LTR (default)
1: G_LTR
2: EXECTIVE
3: K_LGL
4: A_LTR
Setting whether or not to display the box screen of the operating section
<Setting value>
0: Do not display
1: Display [Default]
Setting whether or not to display the send screen of the operating section
<Setting value>
0: Do not display
1: Display [Default]
Setting whether or not to display the fax screen of the operating section
not used
Setting whether or not to display the extended screen of the operating section
<Setting value>
0: Do not display
1: Display [Default]
Selecting the data transfer speed at service network connection
<Setting value>
0: Auto [Default]
1: 100Base-TX
2: 100Base-T
Use it to change the control mechanism used to switch over trays when one
becomes full.
MEMO:
This item is displayed only at the time of Stacker-A1 connection.
Turning the TOT synchronous command communication port ON or OFF
The port for Inquiry/Response (synchronous) command communication in
TUIF over TCP/IP is turned ON or OFF.
<Setting value>
0: OFF [Default]
1: ON
Level
2
2
2
2
2
2
2
2
2
2
2
2
2