Control Panel; Removing The Control Panel Unit - Canon ImageRunner iR8500 Series Service Manual

11.5.13 Control Panel

11.5.13.1 Removing the Control Panel Unit

iR105i/iR105+ / iR9070
1) Disconnect the connector [1].
If for a 230V model, detach the ferrite core [2].
2) Remove the binding screw [1], and detach the lower arm cover [2].
3) Remove the 2 binding screws [4] used to keep the upper arm cover
[3] in place.
[1]
4) Remove the binding screw [1], and detach the rear support cover [2].
5) Remove the double washer screw [3] and the flat-headed screw [4],
and detach the control panel [5].
0007-2993
[1]
F-11-53
[2]
F-11-54
[3]
[4]
[2]
F-11-55
[5]
[4]
6) While paying attention to the claw [2], detach the upper arm cover
[1].
7) Remove the harness clip [3].
[2]
The harness clip will divide into two during the work. Continue the
work, as it will not adversely
affect any function.
8) Free the control panel harness [2] from the 2 wire saddles [1].
9) Remove the 4 binding screws [3] and the positioning binding screw
[4]; then, while paying attention to the claw [6], detach the upper arm
[5]. At this time, be sure to take a note of the position of the binding
screw [4].
Chapter 11
[2]
[1]
[3]
F-11-56
[3]
[1]
F-11-57
11-29