Feeder List - Canon ImageRunner iR8500 Series Service Manual

DOCST
LA-SPEED

17.4.2.3 Feeder List

FEEDER >ADJUST
Sub-item
DOCST
DOCST-M
LA-SPEED
Use it to adjust the original stop position when the ADF is used (original tray pickup).
<Setting range> -10 to 10 (unit: 0.5 mm)
MEMO:
- A higher value decreases the leading edge margin.
- The data is retained by the ADF controller PCB.
<Using the Mode>
1) Make a print of the test chart, and check the position of the image.
2) Select the mode item, and change the setting to make adjustments.
3) Press the OK key.
4) Make a print of the test chart once again, and check to see the position of the image is
as indicated.
Print image
Feed
direction
Higher value Lower value
Use it to adjust the original feed speed in ADF stream reading mode.
<Setting range> -30 to 30 (unit: 0.1%)
MEMO:
- A higher value increases the speed.
- The data is retained by the ADF controller PCB.
FEEDER >ADJUST
Use it to adjust the original stop position when the ADF is used (original tray pickup).
<Setting range> -30 to 30 (unit: 0.5 mm)
MEMO:
- A higher value decreases the leading edge margin.
- The data is retained by the ADF controller PCB.
<Using the Mode>
1) Place an original in the original tray.
2) Select the item, check the setting, and press the OK key.
3) Press the OK key. The original will be picked up.
4) Open the ADF, and check the original stop position.
5) Press the OK key. The original will be delivered.
Print image
Feed
direction
Higher value Lower value
Use it to adjust the original stop position when the ADF is used (manual feed tray).
<Setting range> -30 to 30 (unit: 0.5 mm)
Using the Mode
Same as in FEEDER> ADJUST> DOCST.
Use it to adjust the original feed speed in ADF stream reading mode.
<Setting range> -30 to 30 (unit: 0.1%)
MEMO:
- A higher value increases the speed.
- The data is retained by the ADF controller PCB.
T-17-98
Description
Chapter 17
1
1
0008-7961
Level
1
1
1
17-91