Adjust (Adjustment Mode) - Canon ImageRunner iR8500 Series Service Manual

Chapter 17

17.4 ADJUST (Adjustment Mode)

17.4.1 COPIER
17.4.1.1 Copier List
iR105i/iR105+ / iR9070
<LAMP>
Sub-item
L-DATA
<AE>
Sub-item
AE-TBL
<ADJ-XY>
Sub-item
Adjusting the mage read start position
- If RAM on the reader controller circuit board has been cleared or the board itself has been replaced, enter the value
from the service label.
- If the setting of this item has been changed, enter the new value into the service label.
17-60
COPIER > ADJUST > LAMP
Use it to enter the scanning lamp intensity data.
<Setting range> 0 to 1023
- A higher input value increases the intensity.
- A lower input value decreases the intensity.
If the output shows faulty images after execution of the following, enter the values
indicated on the service sheet: COPIER> FUNCTION> CCD> CCDADJ.
COPIER > ADJUST > AE
Adjusting the character density at image density adjustment
<Setting range> 1 to 9 (Default: 5)
Setting a greater value makes characters darker.
Setting a smaller value makes characters lighter.
If RAM on the reader controller circuit board has been cleared, enter the value from the
service label.
Copy density
White
A higher value makes the text darker.
A lower value makes the text lighter.
COPIER > ADJUST > ADJ-XY
T-17-41
Description
T-17-42
Description
White
Original density
T-17-43
Description
0008-4932
Level
1
Level
1
Level