Canon ImageRunner iR8500 Series Service Manual page 1030

Chapter 17
Sub-item
TR-SP-DK
DEV-SLOW
STPL-SFT
BASE-SW
SC-L-CNT
IDL-MODE
SCANSLCT
OHP-TEMP
OHP-CNT
FIX-TMP1
TRSW-P-B
SP-MODE
17-186
COPIER > OPTION > BODY
Description
Use it to set the transfer/separation output setting when the side paper deck is
used.
<Setting value>
0: setting for plain power (default)
1: setting for recycled paper
2: setting for tracing paper
Use it to set the speed of the developing sleeve.
<Setting value>
0: in relation to environment
1: fixed to high speed
2: fixed to low speed (default)
Use it to specify where to execute shift stacking in staple mode.
<Setting value>
0: perform shift stacking in staple mode (as it is: default)
1: do not perform shift stacking in staple mode
Switching from the MEAP-Full mode to the Base model
<Setting value>
0: OFF (Base model), 1: ON (Full model)
switches the thresh value for the scan counter (large/small).
<Setting value>:0 (B4 as threshold) or 1 (LTR as threshold)
default:0
Use it to select idle rotation mode for the developing assembly.
MEMO:
Set it to '2' or '3' if the image becomes distorted or too light.
<Setting value>
0: OFF (no idle rotation)
1: auto control based on readings of environment sensor (default)
2: start idle rotation when fixing roller temperature reaches 100 deg C
3: start idle rotation when main power switch goes ON
Turning ON or OFF the function of calculating a scan area from the selected
paper size
<Setting value>
0: OFF (Determining the scan area by document detection)
1: ON (Determining the scan area by paper size)
Use it to switch among temperature settings for transparency mode.
MEMO:
The fixing temperature will be lowered to improve separation of
transparencies from the fixing roller.
<Setting value>
0: 198 deg C (default)
1: 193 deg C
2: 188 deg C
3: 183 deg C
Use it to turn ON/OFF the potential control mechanism for transparency
mode.
<Setting value>
0: use target value obtained in potential control of transparency mode
(default)
1: do not use potential control in transparency mode
Use it to select a temperature for starting down-sequence for plain paper.
MEMO:
If the user wants priority on image quality, set it to '0'; on speed, set it to '2'.
<Setting value>
0: 183 deg C
1: 178 deg C (default)
2: 173 deg C
Use it to turn ON/OFF the transfer current output correction mechanism at the
trailing edge of paper.
<Setting value>
0: ON
1: OFF (default)
Use it to turn ON/OFF the separation current output correction mechanism.
<Setting value>
0: standard mode (default)
1: low voltage mode
Level
1
1
1
1
1
2
2
2
2
2
2
2