Canon ImageRunner iR8500 Series Service Manual page 963

Sub-item
TONER-S
CARD
E-RDS
RGW-PORT Reserved for future.
COM-TEST
COM-LOG
RGW-ADR
<CCD>
Sub-item
CCD-ADJ
LUT-ADJ
COPIER > FUNCTION > INSTALL
Stirring toner in the developer at installation
<Operating procedure>
1. Select an item to reverse its display.
2. "Check the Developer" is displayed.
Check that the developer connector is connected.
3. Press the OK key to start operation. The operation automatically stops after count-
down.
<Reference>
"Check the Developer" is displayed to prevent the connector from being disconnected
when the developer is replaced. Therefore, this message is not necessary when the
machine is shipped with the developer for installation.
Installing and setting the card reader
<Operating procedure>
Enter the card number (1 to 2001) and press the OK key. (One thousand cards can be
used from the input card number.)
Then the card management information (department ID and PIN) is initialized.
Reserved for future.
Reserved for future.
Reserved for future.
Reserved for future.
COPIER > FUNCTION > CCD
Automatically adjusting CCD
<Operating procedure>
1) Place about 10 or more sheets of standard white paper (whitest paper used by the user,
excluding color print paper) on the document table.
2) Select <CCD-ADJ> to reverse its display. Then press the OK key.
3) Adjustment is executed automatically (about 15 seconds). During adjustment,
<ACTIVE> is displayed at the upper right of the screen.
4) The LED lamp (for document lighting) lights twice and the automatic adjustment ends
with <OK> displayed on the screen.
5) Since all items are updated in this service mode (COPIER>ADJUST>CCD), enter the
values into the service label.
(rear)
Standard white paper
Use it to execute CCD gain simplified correction.
MEMO:
- After executing CCD-ADJ, execute this mode to adjust the density along the middle of
images.
- Be sure to execute CCD-ADJ before executing this mode.
<Using the Mode>
1) Select the item, and press the OK key.
2) Execute auto adjustment.
3) See that the machine automatically stops after adjustment.
4) All items under the following are updated; print out a service sheet, and store it away:
COPIER> ADJUST> LAMP, COPIER> ADJUST> CCD.
T-17-153
Description
T-17-154
Description
Chapter 17
Level
1
1
1
1
1
1
1
Level
1
1
17-119