Take up roller
2) After mounting the fixing cleaning belt, move the plunger [4] of the
cleaning belt feeding solenoid into the direction of the arrow.
[4]
If you have replaced the cleaning belt, be sure to return the setting under
COPIER>COUNTER>MISC>FIX-WEB to '0' in service mode.
10.5.11 Claw Jam Sensor
10.5.11.1 Removing the Claw Jam Sensor
iR105i/iR105+ / iR9070
1) Remove the fixing assembly.
2) Remove the 2 screws, and detach the lower separation claw assembly.
3) Detach the claw jam sensor [1] from the right side of the lower
delivery assembly.
[1]
10.5.11.2 Removing the Delivery Speed Switching Clutch
/ iR85+ / iR8070
1) Slide out the fixing/feeder unit.
Cleaning belt
feeding roller
F-10-95
F-10-96
0007-2926
F-10-97
0008-8208
2) Remove the fixing motor.
3) Remove the 3 screws [1], and detach the fixing front support base [2].
[1]
10.5.12 External Delivery Sensor
10.5.12.1 Remove the External Delivery Sensor
iR105i/iR105+ / iR9070
1) Remove the external delivery roller.
2) Remove the 2 screws [1], and disconnect the connector [2]; then,
detach the external sensor assembly [3].
[3]
[1]
3) Disconnect the connector [1], and detach the external delivery sensor
[2].
[1]
10.5.12.2 Remove the External Delivery Sensor
/ iR85+ / iR8070
1) Remove the external delivery roller.
2) Remove the 2 screws [1], and disconnect the connector [2]; then,
detach the external sensor assembly [3].
Chapter 10
F-10-98
0007-2928
[1]
[2]
F-10-99
[2]
F-10-100
0008-8210
10-33